Bosch NET 682 C Instrukcja Obsługi Pobierz pdf (Strona 22)

INSTALLATION

INSTALLATION INSTRUCTIONS

20

EXTENDED PLUME

MANAGEMENT INSTALLATION

EXTENDED PLUME MANAGEMENT INSTALLATION

8 718 682 335b (09.2008)

NOTE: to ease assembly of the flue components,

grease seals lightly with the solvent-free grease

supplied.

Check all the seals are seated properly in the

grooves provided and are in good condition.

All flue joints must be sealed to prevent leakage

of condensate and flue products.

1

Remove screws (C) and discard the

complete terminal end (D).

2

Fit the terminal bend (E) to the terminal

outlet and secure reusing screws (C).

3

Rotate terminal bend (E) for angled fluing.

DO NOT rotate the complete flue terminal

assembly.

NOTE: the terminal bend (E) has built-in

stops to limit rotation for horizontal fluing

to allow condensate to run back into the

boiler for safe disposal. Do not force the

bend beyond its limit stops.

All plume management sections must

rise by at least 173mm per metre (10°)

from the terminal to ensure that

condensate flows back into the boiler.

4

Mark, drill (protecting bend (E) from

debris) and fit clamp wall plugs (G).

Screw clamps (F) into wall plugs (G) to

the required distance as shown.

Work from the terminal bend (C) connecting

and clamping to support the weight of the

extensions.

5

Push-fit the extension tubes/bends as

far as possible into the connectors (H),

then withdraw each one by 10mm to allow

for expansion.

6

Align extension clamps (M) in position

as shown and secure with screws (J).

7

Push-fit outlet assembly (L) as far as

possible into the extension tube connector

(H).

Rotate the outlet assembly (L) to the

direction required and secure to the

extension with self-tapping screw (K)

supplied.

E

G

1

E

C

C

D

2

H

M

J

L

K

F

F

G

J

4

4

5

5

6

6

7

M

H

M

10mm

CONNECTORS

CLAMPS

6

5

H

3

65mm

4

F

±80°

1 2 ... 17 18 19 20 21 22 23 24

Komentarze do niniejszej Instrukcji

Brak uwag