Bosch DS7447 Podręcznik Użytkownika Strona 15

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 60
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 14
– 15 –
Standard Operations (continued)
Day to Day Operations (continued)
Normal Disarming
Please read the section about Emergency Procedures prior to being confronted with an emergency event. If you have entered the building
through a perimeter door, you may hear a steady entry alert tone from the wired keypads. If so, disarm according to the chart below.
If an alarm has occurred sometime before your arrival, then the bells and sirens are on, and/or the wired keypads are issuing
a pulsed tone during the entry delay instead of the usual steady tone, and/or the red Armed LED on any DS7445/DS7445i
keypad is flashing, and/or the red Armed LED on any DS7447/DS7447E keypad display is flashing with the reading “Zone
Alarm.” If the alarm has not been previously investigated, do not enter the building unless accompanied by the appropriate
Emergency Services’ personnel.
Note: When in Commercial Fire Mode, entering [PIN] + [#] for a second time on a DS7445/
DS7445i or DS7447/DS7447E keypad allows you to locate the fire zone number(s) in
alarm.
Equipment
Used
Command
Sequence
What Will
Happen
What
To Do
DS7447/
DS7447E
DS7445/
DS7445i
[PIN] + [Off]
The red Armed LED will turn off.
All sounders will silence.
All zones will disarm.
If a fire alarm was sounding, “Sounder Silenced” will
display until system is reset. *
RF3341 [PIN] + [#]
RF3332
RF3334
Press DISARM
button
The LED will flash indicating a signal has been sent
to your security system.
All sounders will silence.
All zones will disarm.
Determine why the sounders, if
any, were sounding.
Correct the cause.
After correcting the cause, if a fire
alarm was sounding, reset the
system using a DS7445/DS7445i
or DS7447/DS7447E keypad.
RF3502 Not Applicable
* DS7447/DS7447E only
** DS7445/DS7445i only
Przeglądanie stron 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 59 60

Komentarze do niniejszej Instrukcji

Brak uwag