Bosch SE2005 Instrukcja Konfiguracji Pobierz pdf (Strona 44)

Security Escort | Installation and Setup Guide |5.0 Testing

and Troubleshootin

EN | 44

Bosch Security Systems | 1/09 | 33831E

Symptoms Probable Cause Possible Solution

Communication

failures from

all

transponders.

1. Loss of power.

2. Cable from ProxLink

to computer.

3. ProxLink Radio

Module might be in

Programming Mode.

4. SE485 Module.

5. Cable from SE485.

6. ProxLink Radio

Module.

1. Check power to ProxLink from central console.

Also, if using SE485, check power to SE485

Module.

2. Must use 25 to 9 pin cable supplied from Proxim.

3. Unplug power to ProxLink and plug back in to re-

start ProxLink.

4. Check wiring between SE485 and computer, and

SE485 at ProxLink Radio Module. Transmit should

be going to receive and receive should be going

to transmit (RX+ to TX+, RX- to TX-).

5. Cable from SE485 to computer must be straight

through 25 pin to 25 pin or 25 pin to 9 pin

depending on your serial port on the back of the

computer. Do not use cable labeled for printer

or null modem cable. Replace cable if bad. Check

cable between SE485 and ProxLink Radio Module.

Replace if bad.

6. Check programming for central console ProxLink

Radio Module to be sure it is correct. If

everything else checks OK, replace ProxLink.

One

transponder in

communication

fail on

ProxLink Radio

Module link.

1. Transponder.

2. Cable from ProxLink

Radio Module to

transponder.

3. ProxLink Radio

Module.

SE485.

a. Check slide switch on transponder to make

sure it is in the RS-232 position.

b. Check DIP switch address for transponder to

be sure it corresponds with transponder data

base.

2. Replace cable.

a. Check power to ProxLink. Make sure radio

power LED is lit.

b. Check antenna connection to ProxLink Radio

Module.

c. Check programming for ProxLink Radio Module.

d. Radio out of range or not in line of sight of

central console antenna.

e. Ice on antenna.

f. If antenna is remote from ProxLink, use RG8U

cable to prevent dB loss.

g. Replace ProxLink Radio Module.

a. Check power to ProxLink to SE485.

b. Make sure slide switch on transponder is set

for SE485.

c. Check wiring from transponder to SE485 (RX+

to TX+, RX- to TX-). Make sure transmit goes

to receive and receive goes to transmit.

d. Replace SE485 Module.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 53 54

Komentarze do niniejszej Instrukcji

Brak uwag

Bosch SE2005 Instrukcja Konfiguracji Strona 44

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa Bosch SE2005