ISW-D8125CW-V2 | Installation and Operation Guide | Operation
12 Bosch Security Systems, Inc. | 8/11 | F01U161691-05
5. At the RF Transmitter Menu (Figure 18), select the
desired action:
- Push 1 to edit: Press [1] to change the RF
transmitter’s point type.
- Push 2 to delete: Press [2] to delete the RF
transmitter from the system. Refer to Section
3.9.5 Deleting an RF Transmitter on page 13.
- Push 3 to continue: Press [3] to add a new RF
transmitter, or change an existing one.
To add a new RF transmitter, refer to Section
3.9.3 Adding a New RF Transmitter on page 12.
To reprogram existing transmitters, refer to
Section 3.9.4 Adding an Existing RF Transmitter
on page 13.
- Push ESC to Exit: Press [ESC] to exit the
current menu option.
3.9.2 Point Type
The Point Type setting determines whether the
transmitter is a burg point or fire point.
3.9.3 Adding a New RF Transmitter
The first point added to the system sets
the allowable point range. For example, if
you add Points 9 to 127 (Zonex 1), the
point range is fixed at 9 to 127. If you add
Points 129 to 247 (Zonex 2), the point
range is fixed at 129 to 247. To clear the
point range, you must clear the EEPROM.
Refer to Section 3.9.7 Clearing the
EEPROM on page 14.
Check the Transmit and Receive LEDs
(TX1/RX1 and TX2/RX2) to verify
communication from Receiver 1 to
Receiver 2.
By default, all new points are assigned as
Burg points and have a fixed check-in
time of 3 minutes.
The supervisory interval for fire points is
fixed at 4 hours regardless of system
programming.
1. After you select a point number, the keypad cycles
through the RF Transmitter Menu options.
- To change the transmitter’s point type, press
[1] then go to Step 2.
- If the transmitter’s point type does not need to
be changed, go to Step 4.
Figure 18: RF Transmitter Menu Options
2. Select from either Burg (default selection) or Fire
for the transmitter’s point type.
3. After you select the point type, the keypad returns
to the RF Transmitter Menu options (Figure 18).
4. Press [3] to continue adding the new RF
transmitter.
5. The keypad presents two options:
- Push 1 for new xmtr. (transmitter)
- Push 2 for existing xmtr.
6. Press [1] to add a new RF transmitter.
7. When the keypad shows Press xmtr resset
button, remove the cover from the RF transmitter
and press the Reset button on the transmitter.
8. When the transmitter is properly programmed, the
keypad shows Pt programmed.
If the transmitter is not properly programmed
within 5 minutes, a three-beep error tone sounds,
and the keypad shows Transmitter not detected.
9. Record the point information in Section 5.0 Program
Record Sheet on page 17 and on the RF transmitter’s
point label.
10. Repeat this procedure to add more RF
transmitters.
(34 strony)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentarze do niniejszej Instrukcji