Bosch D720 Instrukcja Użytkownika Pobierz pdf (Strona 3)

D720 Installation Guide

D720

Setting the Command Center Address

5.3 Command Mode Indicator

When the [COMMAND] bar is pressed, the command mode indicator is lit approximately 15 seconds or until the

command is completed.

5.4 Power Indicator

The Power (PWR) indicator is “on” when AC power is present and the battery is good. The Power ([PWR]) indicator is “off”

when AC power is not present. The Power ([PWR]) indicator blinks slowly when battery power is low and AC is present.

The Power ([PWR]) indicator blinks quickly when battery power is missing and AC is present.

Indicator AC BATT

OFF NO YES*

ON YES GOOD

SLOW YES or NO LOW

FAST YES MISSING

*If AC is not present and the battery becomes depleted,

the command center will

ive no indication at all.

Table 1: Power Indicator Status

6.0 Setting the Command Center Address

Switches 1 to 4 on the D720 assign an address (1 to 8) to the command center (refer to Figure 2 below and Table 2 on page

4). The address determines the area to which the command center is assigned. Switch 5 allows you to enable or disable the

keystroke entry tone, and switch 6 allows you to enable or disable keypad backlighting. The Slide Switches can only be set

while power is removed from the command center. If the switch positions are reset while the command center is powered up,

the changes will have no effect on the subsequent performance of the command center.

123

789

COMMAND

ABCENT

123456

OFF

DIP Switches

Serial Data

Wiring Connector

Wire Opening

Figure 2: Internal Features

1 2 3 4 5 6 7 8

Brak uwag

Bosch D720 Instrukcja Użytkownika Strona 3