Bosch Solution 16plus Dokumentacja Pobierz pdf (Strona 27)

Programming Domestic Telephone Numbers

If your system has been set-up for domestic dialling, this function allows any Master Code

holder to program telephone numbers that the control panel will call in the event of an alarm.

How To Program Telephone Numbers

1. Enter your Master Code followed by 2 and the # button (eg. 2580 + 2 + #).

Three beeps will be heard and the STAY and AWAY indicators will begin to flash.

If there are telephone numbers already programmed, they will be displayed one digit

at a time via the codepad indicators.

If there are no telephone numbers programmed, a further two beeps will be heard after

entering this mode. These two beeps are normally heard after the last digit of the last

telephone number has been displayed.

2. Enter all digits for the first telephone number (eg. 96721717).

You will notice that as each digit is entered, the corresponding codepad indicators will

display.

3. If there is more than one telephone number to be programmed, press *. This will

insert a break between the first telephone number and the second telephone number.

If there is only one telephone number to be programmed, press the # button to exit this

function.

4. Enter all the digits of the second telephone number (eg. 96721055).

You will notice that as each digit is entered, the corresponding codepad indicators will

display.

5. After the last digit of the second telephone number has been programmed, press the #

button to exit this function unless a third telephone number is required. If there is a

third telephone number to be programmed, press the * button to insert a break between

the second telephone number and the third telephone number.

Disable Domestic Dialling

If at any time you wish to cancel domestic dialling (eg. You are moving house and do not

wish the system to continue calling your mobile phone etc), you may enter the following

sequence.

1. Enter you Master Code followed by 2 and the # button (eg. 2580 + 2 + #).

Two beeps will be heard and the STAY and AWAY indicators will begin to flash.

2. Press the * button followed by the # button (eg. * + #).

The STAY and AWAY indicators will now extinguish.

!"#$%&"'()* Operators Manual 27

Electronics Design and Manufacturing Pty Limited ISSUE160.DOC

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 43 44

Brak uwag

Bosch Solution 16plus Dokumentacja Strona 27