Bosch VG4-100 Series Instrukcja Instalacji Pobierz pdf (Strona 93)

VG4 Modular Camera Series Cable and Wire Standards | en 93

Bosch Security Systems, Inc. Installation Manual F.01U.162.025 | 6.0 | 2010.03

5.5.2 Configuring the VG4 AutoDome

1. Disconnect the power to the VG4 power supply unit; then open the unit.

2. Remove the green Serial Communications wire from the P106 connector.

3. Remove the 100 Ohm resistor across the C+ and C- pins.

4. Cut the five wires from the green Serial Communications wire mating connector.

Ensure that the insulation covers each wire to avoid wires from touching.

5. Cut back the insulation on the blue (ground) wire and on the green (RxD) wire enough to

be able to connect these wires back into the P106 connector.

6. Connect the blue (ground) wire to the C- pin on the P106 connector.

7. Connect the green (RxD) wire to the C+ pin on the P106 connector.

Figure 5.8 Detail of P106 Connections

8. Connect the fiber optic cable from the AutoDome to the LTC 4629.

9. Close the door to the power supply unit.

1 Green RxD wire connected to C+

2 Blue Ground wire connected to C-

GND

24 VA

101

P106

P10

XF1

5 4

J103

(

LED

)

HTR DOME

4V NC 24V

GND TXD

RXD

C+

C-

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 107 108

Brak uwag

Bosch VG4-100 Series Instrukcja Instalacji Strona 93