Bosch 7000 Series Instrukcja Obsługi Pobierz pdf (Strona 20)

 Bosch Alarm Panel Interface Manual

Revision 1.4

CCTV Events tab

Allows operator to set CCTV parameters to be sent to CCTV system.

 Alarm number = must be greater than zero; allows user to set the number to send to

the CCTV service/system. Zero means no alarm message is sent to CCTV system.

 Camera, Monitor, Position, fields allow SG to send commands to CCTV system.

 Manual command = if programmed, the user can send commands from the short

menu in the hardware tree.

 URL = if programmed, can invoke commands at the web site

 Note that changes are saved when the [Apply] button is selected

FIG 7d: CCTV Events tab (cropped)

Audio Settings tab

Allows user to set audio indicators for alarm and trouble conditions.

 Click the Alarm Audio / […] button to browse to the desired audio file to be

sounded for an alarm condition.

 Click the Trouble Audio / […] button to browse to the desired audio file to be

sounded for a trouble condition.

 Note that changes are saved when the [Apply] button is selected

FIG 7e: Audio Settings tab (cropped)

Part 4: click the Apply button to save changes

 Once the Alarm Panel is configured and the necessary GCS Services are running,

System Galaxy can begin receiving alarm panel status messages.

Page 20 of 37

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 36 37

Brak uwag

Bosch 7000 Series Instrukcja Obsługi Strona 20