Bosch ISW-BIT1-HAX WLSN INSTALLATION Dokumentacja Pobierz pdf (Strona 47)

wLSN | Reference Guide | 13.0 wLSN Smoke Detector

Bosch Security Systems, Inc. | 3/07 | F01U009440-01 47

4. Squeeze the optical chamber where indicated and pull it up

and away from the detector and discard (Figure 17).

Figure 17: Remove the Detector Cap

1 - Smoke Chamber Base

2 - Optical Chamber

3 - Alignment Arrows

4 - Detector Cap

5. Use compressed air or a soft-bristled brush to remove dust

and dirt from the smoke chamber base.

6. Align the new optical chamber with the base and snap down

into place.

7. To attach the detector cap line the cap up with the detector,

press the cap onto the detector, and turn clockwise to snap

it firmly into place.

8. Observing the proper polarity, install the batteries and the

battery cover. The detector does not fit onto the mounting

base properly if the batteries are not installed.

9. Mount the detector onto the mounting base.

10. Test the detector’s sensitivity.

Refer to Section 13.3 Sensitivity Test on page 45.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 59 60

Brak uwag

Bosch ISW-BIT1-HAX WLSN INSTALLATION Dokumentacja Strona 47