Bosch ISW-BIT1-HAX WLSN INSTALLATION Dokumentacja Pobierz pdf (Strona 55)

wLSN | Reference Guide | 14.0 wLSN Glassbreak Detector

Bosch Security Systems, Inc. | 3/07 | F01U009440-01 55

14.3.1 Entering Test Mode

Place the detector in Test Mode. In Test Mode, the detector’s LED

disable switch (Item 8, Figure 19 on page 51) is overridden. You

can enter the Test Mode locally or remotely.

To enter the Test Mode locally:

1. Carefully open the service door of the detector.

2. Insert a screwdriver into the slot next to the sensitivity

switches that contains the test pads (Item 1, Figure 20 on

page 53).

3. Touch both test pads at the same time with the tip of the

screwdriver.

The Event LED (green) (Item 6, Figure 19 on page 51) flashes

once per sec. If the green LED does not flash, repeat Steps 2

and 3.

The 13-332 Sound Sensor Tester produces extremely

loud sounds and can be hazardous to hearing when used

at close range. Do not point the 13-332 towards

someone’s head.

To enter the Test Mode remotely:

1. Stand within 3 m (10 ft) of the detector.

2. Move the switches on top of the 13-332 Tester to ACTIVATE

and to MAN modes (Items 1 and 3, Figure 21 on page 54).

3. Point the front of the tester towards the detector and press

the red Start button on top (Item 2, Figure 21 on page 54).

The tester buzzes and the green LED on the detector flashes once

per sec. If the green LED does not flash, move closer to the

detector and repeat the procedure.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60

Brak uwag

Bosch ISW-BIT1-HAX WLSN INSTALLATION Dokumentacja Strona 55