Bosch K2200 Series Przewodnik Instalacji Pobierz pdf (Strona 48)

K2200 Series | Installation Guide | 6.0 Configuration and Testing EN | 48

Bosch Security Systems | 7/03 | 17375 1.3 / 46513C

This value also indicates whether a door contact

is fitted or not. If you set this value to 0 the door

controller will not monitor the door contact.

Press [ENT] to save, press [NXT] to go on.

4. You may use a time profile to automatically open

and close the door. Leave this value at 0 (no

automatic control).

Note:

This requires that the Time Profiles be setup

previous to this step.

DR 1 TP 0

Press [ENT] to save, press [NXT] to go on.

Door 1, Lock Mode (Options)

This display consists of 8 settings represented either

by a number or a - (dash). Each setting is changed by

pressing the number for the option. (See the table

below). When set, the number will appear; when not

set, a - (dash) will replace the number. At start up all

settings will be off.

DR 1 M --------

Press [ENT] to save, press [NXT] to go on.

Table 23: Lock Mode Settings

1 Set: Fail-safe (default). The locks will be

continuously powered, power removed to

unlock the door.

Unset: Fail-secure. Power will be supplied to

unlock the door.

2 See Section 5.4.5 Emergency Override/Free

Exit on page 35.

Set: Door contacts (DR1) produce a Free Exit

report.

Request to Exit (DR2) produces Emergency

Override On when pressed, Emergency

Override Off when released.

Unset: Door contacts operate normally.

Request to Exit operates normally.

3 Set: RTE produces Request for Entry report.

Unset: RTE produces Request to Exit report.

4 Set: AVR reader attached.

Unset: AVR not attached.

5 Set: Readykey Alarm Module/AEM attached.

Unset: No Alarm Module/AEM

6 Exit out of hours. This allows personnel with

access controlled by a time profile to use their

keys outside the time profile if they are leaving

through an exit door.

Set: Exit out of hours allowed.

Unset: Not allowed.

7 Set: Readykey PIN reader with time profiles

attached.

Unset: No Readykey PIN reader with time

profiles

8 This is a special setting that is used in

combination with option 2. Leave this Unset

unless specifically required.

Set: DR1 input will operate the lock output and

generate a Request to Exit transaction.

Unset: DR1 does not operate the lock, if used

as a door contact it will generate a Free Exit

transaction

Lock Mode 2 (Options)

This display consists of a further 8 settings

represented either by a number or a - (dash). Each

setting is changed by pressing the number for the

option. (See the table below). When set, the number

will appear; when not set, a - (dash) will replace the

number. At startup all settings will be off..

DR 1 M2 --------

Press [ENT] to save, press [NXT] to go on.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 59 60

Komentarze do niniejszej Instrukcji

Brak uwag

Bosch K2200 Series Przewodnik Instalacji Strona 48

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa Bosch K2200 Series