Bosch DS7445i Podręcznik Użytkownika Strona 49
- Strona / 54
- Spis treści
- BOOKMARKI
Oceniono. / 5. Na podstawie oceny klientów
DS7240/DS7220 User's Guide Copyright 2002 Detection Systems, Inc. P/N: 49211C Page 49
PART III: REFERENCE MATERIALS
Event
#
Event Description Event
#
Event Description
81 Fire, Trbl, Rstl
Restoral from Trouble, fire
detection device(s).
101 Bad Call to RPS
Panel attempted to call DS-RPS, but was
unsuccessful.
82 Instl Mode, Start Installer PIN entered. Installer
Mode accessed.
102 RPS Access Fail DS-RPS attempted to connect to panel, but
was unsuccessful.
83 Instl Mode, End Installer Mode exited. 103 RPS Access OK DS-RPS successfully connected to and
disconnected from panel.
84 Log Overflow
Panel log overflow condition.
Oldest events being overwritten.
104 Re-boot, Panel Normal start-up or reset with Installer Switch.
85 Log Threshold Panel log reached threshold.
Contact Security Company.
105 Re-Boot, Dbus Unexpected reset (reboot) from Data Bus
device.
86 AltCom Low Signl
Low signal strength detected on
alternate communication device.
106 Output Reset, Usr Relay reset by user.
87 Missing, Alarm Zone assigned to zone expander
(wired or RF) not responding to
panel’s status poll while system is
armed.
107 Output Reset, Skd Relay reset by Sked.
88 Missing, Trouble Zone assigned to zone expander
(wired or RF) not responding to
panel’s status poll while system is
disarmed.
108 Output Reset,
RPS
Relay reset by DS-RPS.
89 Open, Skd Opening by Sked. 109 Output Set, Usr Relay set by user.
90 Open, RPS Opening by DS-RPS. 110 Output Set, Skd Relay set by Sked.
91 Open, User Opening by user, ID reported. 111 Output Set, RPS Relay set by DS-RPS.
92 Open, KS Opening by keyswitch. 112 Rstrl, Tamper Restoral from alarm, Tamper zone type.
93 Open, Skd, Alarm Opening after alarm event by
Sked.
113 Rstrl, Emergency Restoral from alarm, Emergency zone type.
94 Open, RPS,
Alarm
Opening after alarm event by DS-
RPS.
114 Rstrl, Panic Restoral from alarm, Panic zone type.
95 Open, Usr, Alarm Opening after alarm event by user,
ID reported.
115 Rstrl, Invisible Restoral from alarm, Invisible zone type.
96 Open, KS, Alarm
Opening after alarm event by
keyswitch.
116 Rstrl, 24-hr Burg Restoral from alarm, 24-hr Burglary zone type.
97 Reserved. 117 Rstrl, Cntrl, Dly Restoral from alarm, Controlled zone type.
98 Params Changed Panel parameters changed. 118 Rstrl, Cntrl, Dly Restoral from alarm, Controlled zone type.
99 Phone Line Fail Phone line voltage falls below
threshold for 40 seconds.
119 Rcvr Jam Jammed condition detected on premises RF
Receiver.
100 Phone Line Rstl
After Phone Line Fail event, phone
line voltage detected above
threshold for 40 seconds.
120 Rcvr Jam Rstl
Jammed condition detected on premises RF
Receiver cleared.
Table 18 (cont.): Panel Event Descriptions
- User’s Guide for the 1
- MY ALARM COMPANY IS: 2
- Contents 3
- Part I: Introduction 4
- 3.0 Keypad Overview 5
- 3.2 Keypad Tones 6
- 3.3 Keypad LED Functions 6
- 3.4 Function Key Sequences 7
- 3.5 System Events 7
- 3.8 Logging Out of the System 7
- Part II: Keypad User’s Guide 8
- 4.7 Set Partial On Zones 10
- 4.10 Force Arming the System 12
- 4.11 View Faulted Zones 13
- 4.12 Bypass Zones 13
- 4.13 Date and Time 14
- 4.14 Change PIN 14
- 4.15 Change Others’ PINs 15
- 4.17 Add a PIN 16
- 4.18 Delete a PIN 17
- 4.19 Renew One-Time PINs 17
- 4.20 Check System Troubles 18
- 4.21 View Alarm Memory 18
- 4.22 View System Trouble 19
- 4.23 View Zone Trouble 19
- 4.24 System Test 19
- 4.25 Walk Test 20
- 4.26 Reset the System 21
- 4.27 Turn Chime On/Off 21
- 4.28 Select Chime Tone 21
- 4.29 Select Chime Zones 22
- 4.30 Extend Auto-On Time 22
- 4.31 Change Skeds 22
- 4.32 Change Outputs 25
- 4.33 Remote Program 26
- 4.34 All Areas Off 26
- 4.35 All Areas On 26
- 4.36 Move to Area 27
- 4.37 Auto-Forward On Setup 27
- 4.38 Auto-Forward Off Setup 28
- 4.39 Auto-Forward On/Off 28
- 4.41 View Log 29
- 5.1 Silence Alarms 30
- 5.2 Keypad Adjust 30
- 5.3 Turn the System Off 30
- 5.4 Turn the System All On 31
- 5.7 Set Partial On Zones 32
- Flashing Armed LED 33
- 5.10 Force Arming the System 34
- 5.11 Bypass Zones 35
- 5.12 Date and Time 35
- I can perform this function 36
- 5.17 Delete a PIN 39
- 5.18 Renew One-Time PINs 39
- 5.19 Check System Troubles 40
- 5.20 View Alarm Memory 40
- 5.21 View System Trouble 40
- 5.22 View Zone Trouble 41
- 5.23 System Test 41
- 5.24 Walk Test 42
- 5.25 Reset the System 42
- 5.26 Turn Chime On/Off 42
- 5.29 Extend Auto On Time 44
- 5.30 All Areas On 44
- 5.31 All Areas Off 44
- 5.32 Auto Forward On/Off 44
- 5.34 Remote Program 45
- Part III: Reference Materials 46
- 7.0 Panel Event Descriptions 47
- 10.0 Maintenance and Service 52
- 11.0 Power Failure 52
- 12.0 How to Clean the Keypad 52
- 13.0 Glossary 53
- Detection Systems, Inc. 6/02 54
- P/N: 49211C Page 54 of 54 54
Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa Bosch DS7445i
(175 strony)
(44 strony)
(8 strony)
(64 strony)© 2020, manymanuals.pl. Wszelkie prawa zastrzeżone. | 0.047 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentarze do niniejszej Instrukcji