Bosch D1260 Series Przewodnik Instalacji Strona 13

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 20
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 12
D1260
Installation
D1260 Installation Guide
© 2003 Bosch Security Systems Page 13 48101D
3.5 Wiring
A 4-wire flying lead is required for the data and power connections between the D1260 and the panel. The D1260 comes
with a wiring assembly consisting of four color-coded flying leads and a female 4-pin connector plug at one end. Wire
resistance must not exceed 14 .
It is recommended that 18 AWG wire be used when connecting a D1260 to a control panel.
To wire the D1260:
1. Power down the panel.
2.
Using a small flat-blade screwdriver, gently push in the two
bottom tabs of the D1260 enclosure cover. As the tabs are pushed
back, lift the D1260 cover away from the backplate.
3. Set the address switches as shown in Section 3.2 Setting the DIP
Switch on page 12.
4.
Connect the flying leads of
the wiring assembly
(provided) to the wires
from the panel, as shown
in Figure 9.
POWER +
32
DATA BUS A
31
DATA BUS B
30
COMMON
29
SDI Common
SDI Data Bus B
SDI Power
SDI Data Bus A
Represents the entire length
between panel and D1260
SDI Connector on
D1260 Keypad
Figure 9: 9000 Series panel to D1260 Flying Leads Wiring
5. Turn the command center over and plug in the
wiring connector through the opening in the back
of the enclosure base (see Figure 10).
6.
Mount the command center base in the desired
location. (See Section 3.1.2 Mounting the Backplate
on page 11) Secure it in place using the mounting
holes inside the enclosure base.
7.
Replace the cover. Align and insert the top two
tabs of the enclosure cover into the top two tab
slots of the enclosure base. Hold the top edges of
the enclosure cover and base in position. Push the
tabs inward and press the enclosure and cover
together until the cover snaps into place.
Figure 10: Wiring Connector
Przeglądanie stron 12
1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Komentarze do niniejszej Instrukcji

Brak uwag