Bosch D1260 Series Przewodnik Instalacji Pobierz pdf (Strona 15)

D1260

Programming the Panel

D1260 Installation Guide

4.0 Programming the Panel

The D1260 Command Center is compatible with the D9412G, D7412G, D7212G, D9412, D7412, D7212, and D9112

Control/Communicators with versions 6.40 or higher. To program the D1260, version 1.15 or higher of the 9000MAIN

handler or version 3.60 or higher of RAM IV is required.

4.1 Enabling the D1260 Command Center

In RAM IV, it is located in the COMMAND CENTER (9000MAIN)

section and called Enhanced Command Center.

This prompt must be turned to YES for the command center addresses on

which D1260s will reside. Figure 11 assumes the D1260 is CC Address 1.

For more information, refer to the panel’s Program Entry Guide.

Figure 11: Enhanced Command Center

prompt in RAM IV

The Display Revision (Command 59) function (in RAM IV found under

USER INTERFACE (9000MAIN)  Command Center Functions) must

be enabled (E) in the panel’s programming for the D1260 to work.

Figure 12: Enable Display Revision prompt

in RAM IV

After the first time a RAM programming session has been completed, but

before exiting RAM IV, the panel will have to be reset for use by using the

reset bye function (click the Reset panel checkbox before clicking OK).

In not, the display will show Incorrect Panel program settings…“Enhanced

CMD CTR” should be set to YES (see Figure 13).

Figure 13: Incorrect Panel display

1 2 ... 10 11 12 13 14 15 16 17 18 19 20

Brak uwag

Bosch D1260 Series Przewodnik Instalacji Strona 15