
3.
Body
Service
,
a
IMPORTANT
Do
not
use benzine or thinner to clean the body. Also make sure that the volatile substances
such as insecticides do not come into contact with the body as these substances may
deteriorate
[he body or strip its paint.
@
Gently wipe stains from the body with a soft cloth. To remove stubborn stains,
wring
a cloth
moistened with neutral detergent diluted with water, and wipe off the stains with it. Wipe
off
any
moisture with a dry cloth.
5.
Replacing
Lid
Gasket
8
Lid gasket with
a
whitened edge may cause steam leakage. Replace the lid gasket,
if
whitened,
in accordance with the following procedure:
@
Open the lid.
@
Apply the minus screwdriver to the underside
of
the gasket band, and
pry
it up. Pull out the
old gasket.
@
Using a waste cloth wipe any dirt off the
portion of the working chamber with which
the gasket was in contact.
@
Remove the gasket band from the old gasket,
and using a waste cloth wipe any dirt off the
gasket band.
@
Attach the gasket band to the new gasket:
(1) Place the new gasket on a flat surface, and
0
Cord
which
prevents the
push in the gasket band until it hits against
gasket band from coming off
the bottom of the groove.
I-
Gasket band
(2)
Insert the cord which prevents the
gasketband from coming off.
@
Install the new gasket in the working
chamber:
(1) Push in the gasket until the entire projected
portion of the gasket hits against the rim of
the
working chamber.
Gradually and evenly
insert the entire gasket while pressing your
palm on the gasket.
*
If the gasket band starts to come off, press
the wooden stick against it to shove the band
into the groove in the gasket while taking
care not to damage to the gasket.
Cross Section
of
@-(I)
-
,_,
Projecte
portion
charnbe
,
Metal
........................
surface
........................
,,--
If
Band Comes
011
--:
Use
a
wooden
stick
lo
push
in
Re
band.
\/
t
Komentarze do niniejszej Instrukcji