
(2)
Push in the gasket unit it hits against the
metal surface. When the gasket is
@-
(2)
d-
Flat porton
completely pushed in, the flat portion is
positioned at a level slightly lower than the
.........................
After compleimg the packrng
rim of the working chamber.
........................
installation, remove the ford
which
prevents the packing band
(3)
In addition, run your finger down the flat
from coming off.
portion of the gasket to eliminate any
irregularities on the gasket surface.
An uneven gasket surface makes the lid
I
I
difficult to close.
a
Pull out the cord which prevents the gasket
band from coming off.
@
Follow the ordinary operating procedure to
start operation and check the lid gasket for
I
any leakage.
6.
Replacing Backup Battery
0
When the
CILOC
K
display flickers, Replace the backup battery in accordance with the
following procedure.
0
Do not dispose of used batteries in fire; they may explode.
r
/
Connecting the battery with its polarities reversed may cause heating, explosion or ignition.
I
1
i
@
Turn
OFF
the power switch.
@
Remove the panel from the right side of the body.
Connector
@
Hold both the ends of the connector for the backup
battery between your fingers, and pull the connector
out of the switch board.
@
Remove the screw from the clamp.
@
Attach the clamp to
a
new battery, and tighten the
screw to secure the clamp on the switch board.
@Insert the connector for the battery into the printed
circuit board, being careful not to make a mistake in
its positioning.
/
connector
Attach the side panel to the body.
@
Turn
ON
the power switch, and correct the clock.
When the correction of the clock is complete, the
CLOCK
display goes out.
@
In
the case a setting other than the values initially set
is used, set the values again.
Komentarze do niniejszej Instrukcji