Bosch AMAX panel 4000 EN Przewodnik Instalacji Pobierz pdf (Strona 24)

Wall Tamper

Jumper

Wall Tamper disabled

(Default position

)

ADDR

Wall Tamper enabled

Jumper left on pin for storage only.

Figure 5.15: Wall Tamper Jumper

– Replace the inner cover.

– Place the spring from the hardware packet over the shaft of the tamper switch located on

the back of the receiver (see Figure 5.16).

Rear of Receiver

Figure 5.16: Rear of Receiver

Notice!

Cause of Hazard

Gently press the spring onto the tapered shaft. Do not force it down onto the shaft

Mounting the Receiver

• Determine the receiver’s mounting location.

• If not already done, remove the receiver’s cover (as shown in Figure 5.13).

• Place the receiver base on the wall at the desired mounting location and mark the two

mounting holes (see Figure 5.17).

24 en | Optional Modules and Peripheral Devices

AMAX panel 4000 / AMAX panel 4000

2013.07 | 03 | F.01U.267.112 Installation Guide Bosch Sicherheitsysteme GmbH

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 175 176

Brak uwag

Bosch AMAX panel 4000 EN Przewodnik Instalacji Strona 24