Bosch AMAX panel 4000 EN Przewodnik Instalacji Pobierz pdf (Strona 58)

In a multi area system the following table shows area assignment and keypad indication of

zones:

Zone Number Area Indication keypad area 1 Indication keypad area 2

1 2 1

2 2 2

3 1 1

4 1 2

5 1 3

6 1 4

7 2 3

8 2 4

9 2 5

10 2 6

11 1 5

12 1 6

Outputs

Onboard / Extension Output

The alarm control panel is equipped with four on-board outputs and supports two DX3010

output extension modules with each extension module supporting 8 relay outputs, 20 outputs

in total.

When on-board output 1 or 2 fails due to a short circuit or open circuit, as long as there is a

backup power supply, the output fault will not affect the normal operation of the whole

system, but will be detected by the system.

Each output is programmable and can be set to follow multiple events.

Depending on the type of output event, the output parameters can be defined as area output

or follow zone alarm output. The output polarity of each output can be programmed and

defined as three modes: continuous output, pulse output or inverted.

The maximum time of each output is specified by programming and will be automatically reset

after expiration.

Electrical characteristics: 13.65VDC ± 3%. For PO-1+2, Max 750mA; PO+3+4, maximum

500mA.

Output Events

0 - Not Used

1 - Disarmed 0=all areas, 1-16 = Areas1-16

The output operates on below conditions:

1. System disarmed after system reset

2. System operated the disarm command

The output is reset:

1. When the system is armed

2. When the output programmed duration is up

7.3

7.3.1

7.3.2

58 en | Settings

AMAX panel 4000 / AMAX panel 4000

2013.07 | 03 | F.01U.267.112 Installation Guide Bosch Sicherheitsysteme GmbH

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 175 176

Komentarze do niniejszej Instrukcji

Brak uwag

Bosch AMAX panel 4000 EN Przewodnik Instalacji Strona 58

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa Bosch AMAX panel 4000 EN