Bosch B450 Przewodnik Instalacji Pobierz pdf (Strona 52)

System Operations

This section explains the general operations of the system: arming and disarming the system

in the three modes, isolating zones, initiating codepad alarms, and determining a fault.

Operations described in this chapter are based on use with the IUI–SOL–ICON codepad. For

the IUI-SOL-TEXT codepad, follow the prompts on the codepad display.

Arming the system in AWAY Mode

Arming the system in AWAY Mode is normally performed when you leave the premises and

require that all zones are activated in a ready state to detect an intrusion.

There are two different methods to arm the system in AWAY Mode. You can always use

method one. You can use method two only if Option 2 is enabled in Location 497 (refer to

Consumer Options 2, page 109).

If you must isolate a zone (or zones) before arming the system in AWAY Mode, refer to

Isolating zones, page 56.

Notice!

Single button arming in AWAY mode reports as user code number 00.

To arm the system in AWAY Mode (method one):

1. Enter your code and press [AWAY].

2. Two beeps sound, the AWAY indicator lights, and Exit Time starts.

To arm the system in AWAY Mode (method two):

Notice!

Select Option 2 in Location 497 to enable single button arming in AWAY Mode (refer to

Consumer Options 2, page 109).

1. Press and hold [AWAY].

2. When two beeps sound, release the button.

The AWAY indicator lights and Exit Time starts. If a zone is not sealed at the end of Exit Time,

the zone is automatically isolated and its indicator is lit on the remote codepad. The zone

becomes an active part of the system again as soon as it is resealed. For example, if a window

is open when Exit Time expires, the window is not an active part of the system until it is

closed. Opening the window after Exit Time expires causes an alarm.

Forced Arming

Arming the system when a zone is not sealed is known as forced arming. Refer Zone Options 2,

page 94 to enable forced arming for each zone.

If the AWAY indicator does not light and a long beep sounds when you attempt to arm the

system in AWAY Mode, forced arming is not permitted. If this is the case, you seal all zones or

manually isolate them before you can arm the system.

Disarming the system from AWAY Mode

When you enter the premises after the system is armed in AWAY Mode, you must disarm the

system from AWAY Mode to disable detection devices that activate the sirens, strobe, and bell

outputs.

If there was an alarm prior to disarming the system from AWAY Mode, a zone indicator flashes,

indicating a previous alarm in that zone.

To disarm the system from AWAY Mode:

6.1

6.2

52 en | System Operations Control Panel

2014.07 | 00n | F01U298026 Installation Guide

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 151 152

Komentarze do niniejszej Instrukcji

Brak uwag

Bosch B450 Przewodnik Instalacji Strona 52

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa Bosch B450