Bosch DS7200V2-EXP Podręcznik Użytkownika Pobierz pdf (Strona 10)

DS7200V2-EXP | Expert Programming Guide | 4. Control Panel Programming EN | 10

Bosch Security Systems | 8/04 | 4998153891C

Format for Destination 1 (2)

• Address:

− Format for Destination 1: 0064

− Format for Destination 2: 0130

• Default: 2 (Contact ID)

• Selections: 2 to 4, 7, 11

− 2 = Contact ID

− 3 = SIA 300

− 4 = Basic Pager

− 7 = Personal Dialing Format

− 11 = SIA 300 with Text Blocks

This parameter selects the reporting format. All reports for this destination are sent in the format chosen here.

If you configure the control panel for network communication, you must set this parameter to Contact ID. See

Network Communication on page 129 for more information. Firmware revision 2.10 or greater is required for

network communication.

Check communications from control panel to Alarm Receiving Center (ARC) to verify that the control

panel is communicating properly in the selected reporting format.

4.2.2 Reporting Format Configuration

Personal Dialing Format

Select the Personal Dialing Format by entering “7” into the appropriate reporting format address. See Format for

Destination 1 (2) on page 10 for more information. The control panel calls a phone number where a person is

expected to answer.

The control panel starts by placing a phone call. The control panel then sends the first digit of the report, waits

one second, and then sends the second digit of the report. The control panel then waits three sec, and sends the

report again. The control panel continues to repeat the report for a total of ten times. Some reports have zero as

the second digit. In these cases, only the first digit is sent, the control panel waits approximately three sec, and

then the report is repeated.

During the three-second delay between each report, pressing [5] on the phone’s keypad acknowledges the report.

The control panel advances to the next event in the dialer queue and sends it in the same phone call, or hangs up

if there are no more events to report. The control panel send each report up to ten times or until it is

acknowledged.

If no one acknowledges the report after ten tries, the control panel hangs up and calls again. If two phone

numbers are programmed for the destination, the second phone number is called. The control panel follows the

normal event phone routing. For each event, the control panel tries five times or until the event is acknowledged.

If no acknowledge is received in the five phone calls, the control panel logs a communication failure for the

destination.

The control panel divides all possible events into Event Groups as reported to RPS. This event group selects

which report to send. The event groups are numbered 1 to 16. The following table lists the 16 possible event

groups. Table 31 details all events generated by the control panel. Not all events are transmitted in Personal

Dialing Format.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 155 156

Brak uwag

Bosch DS7200V2-EXP Podręcznik Użytkownika Strona 10