Bosch DS7200V2-EXP Podręcznik Użytkownika Pobierz pdf (Strona 19)

DS7200V2-EXP | Expert Programming Guide | 4. Control Panel Programming EN | 19

Bosch Security Systems | 8/04 | 4998153891C

4.2.4 Global Reporting Options

These parameters configure the reporting for all areas, all zones, and all users.

Global Reporting Options

• Address: 0221

• Default: 1

• Selections: 0, 1, 3, 5, 7, 9, 11, 13, 15

Enter This Data Digit to Select Options

Global Reporting Options 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Local Only

•

Enable Reporting

•

• •

Extend Handshake

•

Delay Alarm Output

•

• •

Burg Alarm after Two Failed Attempts

•

• •

• Local Only: The control panel sends no reports.

• Enable Reporting: If this option is enabled, the control panel sends reports as programmed provided that at

least one phone number (or IP address) has been programmed for at least one Routing Destination (see Phone

Number 1 (2) for Destination 1 (2) on page 9). Reporting options can be enabled and disabled in other

parameters. See Open/Close Reporting Options on page 39, and Area # Opening {89-96}/Closing {42-67} Reporting

Options on page 49 for more information.

• Extend Handshake: If this option is enabled, the control panel finishes dialing the ARC receiver and waits

for a ‘handshake’ tone from the receiver. The handshake is the first thing the receiver sends after answering

the phone. Typically each reporting format the receiver supports has its own handshake tone. If a receiver

supports several formats, it sounds the handshake tones one at time. Choosing this option extends the time the

control panel waits for a handshake from the ARC receiver from 45 to 60 sec.

Do not change the Extend Handshake option unless advised by Bosch Technical Service.

• Delay Alarm Output: If this option is enabled, the control panel delays burglary alarm output until

communication to the ARC receiver is complete or there are two failed dialing attempts. The delayed alarm

output functions are 1|8, 1|9 and 1|10 (see Table 25 on page 112 for descriptions of output function types). Bell

Time is not delayed, and begins at the alarm event. If Bell Time is set at three min. or less, alarm output

delayed by this option may be very short (less than 1 minute), or the alarm output may not activate at all. See

Output Parameters on page 107 for a complete description of output functions. The keypad sounder is not

delayed by this option.

Disable the Alarm Event Abort option when using the Delay Alarm Output option. See Options 1, Zone

Function ## on page 95.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 155 156

Komentarze do niniejszej Instrukcji

Brak uwag

Bosch DS7200V2-EXP Podręcznik Użytkownika Strona 19

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa Bosch DS7200V2-EXP